- Prices are based upon the size and complexity of the design.
- Price breaks are offered for larger quantity runs.
- A drawing with dimensional information is required.
- A setup fee is required for custom work.*
*This is a one-time per design fee that will be determined after the receipt of the drawing. Hand-drawn submissions will generally require a higher setup fee.
Email [email protected] to Get a Quote.
Mail us a hand-drawing or items to be reproduced.
ATTN: David Butler
137 Worth Beverage Drive
Burgaw, NC 28425
Since quotes are based on size and complexity, a good starting point is
knowing the hole layout and overall size of the piece. The best way to show
this is with a drawing that includes measurements of distances between
hole centers and the left side and bottom of the piece, hole diameters, and
overall piece size. Take a look at the example below:
Accurate dimensional information is needed most. If you are good with a
CAD program, and can provide the labeling and design information in an
exploded format, then that's good because the setup fee will be less.
Exploded format is one with all shapes including letter characters outlined.
Even better, if you can provide a 1:1 scale drawing in a .dwg or .dxf file
format with all of the exploded design information, you will save most on
the setup fee. If you don't want to deal with the tedium of laying out the
actual design, that's ok, we can do it for you, just let us know what goes
where. We'll send a proof in .pdf format that you will approve before the
final piece is produced.
If you need a quote for a logo, we will need to know its overall size. Most
importantly, we will need a drawing that includes vector line information,
and if this is not possible, then the original file may work as long as it is
not in a .jpg or .jpeg file format. Below is an example of what you may see
in a proof of a logo: