Pre-Wired Strat Blender Guitar Wiring Harness
The Fender style Blender wiring kit uses one volume, one master tone, and a blender pot. In the neck position you can blend the bridge pickup in to varying degrees. In the bridge position you can blend the neck pickup in to varying degrees. In positions two and four all three pickups are on at once. Use push on knobs only.
Included:
- (2) CTS 250k vintage taper audio split shaft 7% tolerance potentiometers
- (1) CTS Blender 250k audio split shaft potentiometer
- (1) CRL 5-way switch
- (1) Switchcraft mono input jack
- (1) Vitamin T Oil Filled .047uf capacitor
- (2 ft) Pre-tinned cloth covered black wire
- (2 ft) Pre-tinned cloth covered white wire
- (1) Volume mod cap and resistor
Ratings & Reviews
5 reviews
2/17/2021 1:48 pm
Easiest wiring job I've ever done
by John Aunspach -
Easiest wiring job I've ever done. The tone variations are beyond any other guitar I own and this was just going to be a beater (Rat rod) guitar. Now its moved up quite a few notches to be close to my number one. Thanks Mojotone!!
2/17/2021 1:48 pm
Fender should do this standard
by Drew Leitch -
Hi. I wired my stratocaster to have 1 blender pot so i can blend in the bridge or neck pickups. I also used a blender pot for the master tone control so between 9 and 10 it is out of the circuit. I dont know how the same pot works for these two different mods, but they do and my strat has more tone variations. Fender should do this standard.