• Home
  • Pre-Wired Reverse Tele Custom Guitar Wiring Harness

Pre-Wired Reverse Tele Custom Guitar Wiring Harness

SKU: Z4T3W119R
Weight: 0.8 lb
Sale Unit: Piece

In Stock


It's all about the tone! There's no words to describe the highest level of quality we provide with our wiring kits and components. Bring your guitar to life with our smooth custom taper CTS potentiometers and creamy sounding oil filled Vitamin T capacitors for a vast improvement over your stock electronics!
This is a 3-Way Fender Custom Tele or Fat Tele style kit. Designed specifically with 500k pots for Telecasters with a humbucker or P-90 in the neck and a single coil in the bridge. It uses a 470k resistor in series with the single coil bridge pickup to give the single coil a 250k load, while giving the humbucker it's proper 500k load. Use 1/4'' diameter set screw knobs for the solid shaft pots. Controls are reversed so that the volume is first, followed by the tone, then the switch. 
  • -Mojotone custom CTS 500k solid shaft potentiometers 
  • -CRL 3-way switch 
  • -Switchcraft mono input jack 
  • -Mojotone Vitamin T Oil Filled .047uf capacitor 
  • -Pre-tinned cloth covered wire 
  • -Volume mod (Treble Bleed)

Switch Positions: 
1. Bridge 
2. Bridge & Neck 
3. Neck

Ratings & Reviews

2 reviews

  • 3 stars
  • 0 reviews
  • 2 stars
  • 0 reviews
  • 1 star
  • 0 reviews
8/10/2021 5:44 pm

reverse tele custom harness. recommended by an online review.

by Bruce -

I put this in a 05' G & L Bluesboy. The original electronics were marginal at best. Seth Glover in neck, original pickup in bridge. Disliked the sound in the middle position at first. After a few days, like it. The reverse concept is nice as I wanted the volume close to the bridge. I was disappointed with the force it takes to do volume swells. This may improve with use.

2/17/2021 1:48 pm

this control plate is the recipe

by Ian Hutchinson -

I was having difficulty getting the 57 PAF humbucker in the neck of my Keefer tribute Tele to compete with the '52 SC in the bridge. Tried a few caps.. this control plate is the recipe...and was easy to install. I went with the optional bridge ground wire , and plugged it in... it now sounds great in all 3 pu settings!. Great pot choice BTW, very usable sweep for vol and tone.