The all-new TAD 12BH7A-STR combines the best sonic and mechanic performance of the NOS RCA black plate with the GE version. A maximum of reliability with outrageous tonal quality makes the new balance selected TAD 12BH7A-STR the first choice for Ampeg SVT´s, the Blackstar HT-5 and high-end applications6 Month Limited Warranty against Manufacturing Defects
Maximum of Reliability - Outstanding Tonal Quality! 1st Choice for Ampeq SVTs!
The all-new TAD 12BH7A-STR combines the best sonic and mechanical performance of the NOS RCA black plate with advantages of the GE version. A maximum of reliability with outstanding tonal quality makes the new balanced selected TAD 12BH7A-STR the first choice for Ampeg SVT´s , the Blackstar HT-5 and high-end applications.Q: When does a preamp tube become a Premium Selected tube?A: All preamp tubes labeled Premium Selected have passed the following tests:
- Low Noise Test
- Microphonic Test
- Gain Test
- Sonic Tests
- Shock Tests
- Listening Tests
- Balanced Output Test
TAD does all TAD Tube quality control processing in-house under strict control of their technical staff. Their techs which are also musicians and guitar players, developed and constructed their custom tube testing systems and aging rigs to run tubes in real amplifier circuits and operation conditions.
For TAD, real tube quality control is way more than just a simple test. Before a TAD Tube gets accepted at all the techs perform extensive sample evaluation testing for consistency, power test, shock resistance test, soak test (long term operation at full power) and of course a musical test in known amplifiers to learn about its sound character in different styles. The main tests are made after a proper pre-aging to stabilize the cathode emission. While most tube test equipment does work at 250V as a maximum TAD built their test rig to operate at voltages of 360 to 600V depending on the tubes being tested. Every TAD Tube is tested by their qualified staff. Each pentode is inspected and tapped while operating and listened for noise floor, hum and odd noise.
Finally measured for a set of parameters and matched by Ia (PC) and Gm (TC). TAD tests batches of 400 to 500 pieces per run to allow tightest tolerances of typically 0.5mA for PC. All TAD Tubes and boxes get labeled with the PC and TC test results and a unique serial number to identify every tube they’ve ever tested. TAD techs permanently verify and monitor selected and matched TAD Tubes by using them every day in their own amp service department and in the TAD Amp Kits they assemble. This is the most complete quality control system they can imagine.
All done in-house at TAD in Germany