Used by the pro’s in our very own woodshop for over 20 years, our Mojotone Tweed and Tolex glue is the best material to use for your new custom build and/or your timeless classic. Whether you’re doing a small repair or wrapping a run of cabinets, you don’t want to settle for anything other than what we use on our own cabinets.
How to use our Mojotone Tolex Glue? Make sure both surfaces (wood surface & backer side of tolex/tweed) are dry and clean, apply our Mojotone Glue to both the wood surface and the backer side of the tolex/tweed. Allow 20-30 minutes for our glue to settle and dry, the material will almost become transparent. At that point, you should apply the tolex to the wood surface. Our Glue is very forgiving, you’ll be able to maneuver and reposition our tolex as you apply it to the wood surface. This helps to yield a super clean look… especially for corners and seams.
Note - Use forced air for faster drying times.
Our glue is a water based material and should not be stored in extremely cold climates (below 32 F) or extremely dry/warm climates (Above 105 F) for long periods of time. Make sure to reseal your glue after each use.
Your amplifier bleeds confidence; you should have the same confidence in the materials keeping your amplifier tolex tight and in place. Don’t settle for less, do yourself a favor and use our Mojotone Glue for your tweed and tolex covering needs.
Material Safety Data Sheet